Sun Visors for Acura TSX
Sun visors on the Acura TSX sedan ensure that the driver and passengers are protected from intense sunlight. Over time you may need to replace the parts due to normal wear and tear. With a wide selection of sun visors for Acura TSX, you can find the replacements that you need.
What types of visors are there for the TSX?Sun visors are present on both the passenger side and the driver side of this luxury sedan. They can also be found on the side windows, while others removable and large enough to cover the entire windshield when the car is not in use. They are usually made of an opaque material that blocks out the sunlight.
A visor may either be manually or electrically run. Most vehicles, including the TSX, are fitted with manual visors which are easy to operate. You can, however, have your Acura TSX fitted with the electric version if you wish. Some visors have mirrors and interior lights on them.
What may cause visors to malfunction?The constant flapping up and down while adjusting may affect the hinges of the visors at some point. They become loose and eventually fall out of place. Another probable cause may be stuffing excess items that may over weigh the visor. Sometimes, the plastic holding the visor into place hardens and breaks. In such an event, you will be required to replace or repair it.
Can you replace the visors on an Acura?You do not necessarily need a mechanic to repair or replace the visors in your Acura TSX. This is among the basic vehicle repairs that anyone can accomplish with little knowledge. With these simple steps, you should get the job done:
- Check the model number on the old visor. This will help you purchase identical replacements for your Acura TSX. Also, note that the model number may not match, but the visor might still be compatible with the Acura TSX.
- Take off the plastic piece that hides the screws. Loosen the screws and pull the visor out from the car ceiling. Make sure that no joints are broken in the process.
- Compare the old visor with the new one just to confirm that they match. Position the new one into place and fit it to the ceiling. The side with the mirror and label should always face the driver’s side.
- Insert the screws back and tighten them. Flap the new visor up and down to check if it is working correctly.